Rusting not only reduces the aesthetics of the car, it also corrodes the structure causing much damage. This happens when a car is exposed to the elements. It interacts with the ferrous metals on the vehicle’s body. An interesting fact is more cars are sent to the junkyards today due to rusting than mechanical failures. A tiny section seen on the outside means that there is a huge damaged section underneath.

There are two ways to prevent this from happening. First is to request a standard factory undercoating and rustproofing upon purchase of the vehicle. Most of the time this isn’t sufficient as it is only applied to some surfaces like unfinished metals. These are covered by petroleum-based compounds. Second, is to rust-proof your car by doing it yourself or getting the service of professionals The differences are in price and quality. A do-it-yourself kit will only cost one fifth the price for this service. Fully and competent professional rust proofingcosts a bit more, but it is convenient and usually more thorough. When the car is way over three months old or when it has traveled more than 3,000 miles, treatment is not practical. It must be done before the time when moisture has entered and locked in dirty sections. Otherwise the rust proofing treatment can lock in the moisture and will continue the corroding process. You can find on-line at this link any number of highly recommended auto collision and rust repair shop automotive rust and corrosion prevention and repair products. Included in the mix are rust preventative paints, sealants many of which are extreme high temperature rated and tested for metal motor parts themselves.

Having professional work done might be pricey. It’s usually five times more than the price of a do-it-yourself kit. However, it is convenient and they can do a more thorough job. Kits have enough material for you to work on a full-size car. These come with detailed instructions as well. Once the car is dry, it would have taken the owner 4-5 hours for the whole process. Individuals are advised to wear goggles. Use old clothes while working on the car. You might need to change twice or discard the articles of clothing afterwards. Yet in the end it might be said that you get what you pay for. Pay now or pay later might be the refrain.Its pay for that vehicle upkeep properly now or start shopping for a new – certainly more aesthetic truck or car. Nothing is for nothing so to speak and there is no such thing as a free lunch. Yet one other option is to find a means of having the work done professionally at a cheaper price. Many auto dealers don’t do the work themselves and farm it out to a third party. Ask the service writer nicely at your local G.M. Chevy or Toyota dealership where they send their rust proofing to. You can say that you a fussy customer and want the job done right. They may just cough up the name of the auto service shop they farm out to and use as a third party provider. Then you can go direct and cut out the middleman to have the rust protection service done at less outlay to your pocketbook.

Do not apply to areas which are exposed to heat, like the engine, transmission, driveshaft, manifold, exhaust, pipes, catalytic converter, and radiator core. Rubber seals, tubes and gaskets because it makes them brittle. Don’t start the process during very humid days when surfaces are damp.

Prior to application, get a professional steam engine-clean. Use a wire brush to remove loose dirt and rust. Drain holes must be cleared. Prepare safety jacks so that the under-body can be treated. Be sure to include the exterior removable trims on the car like, holes and clips. You are on your way to a rust-free vehicle!

There are many reasons for a car to allow good metal to corrode and deteriorate. The main reason is when the paint is chipped or scratched through the primer coat, perhaps by stones on the road or a minor car accident, and the metal underneath is exposed to moisture and air, which causes the metal to oxidize.